• Cutting machine for Heat shrink Tubes, Plastic Sleeves &
    Power Chords : CTO 13



    cutting-machines-CTO13

    M/s ‘machine makers r.s.’ have developed and manufactured Cutting machine for Heat shrink tubes as well as other plastic tubes and sleeves. It cuts the sleeves to accurate length and also that too at a very high speed...

    The machine uses special guides for different types and sizes of sleeves/tubes. This ensures a good cut. All other setting is completely digital.

    This machine is tabletop, user-friendly, and automatic. It is available with Microprocessor controls.

    A simple and smart keypad and display is used for setting the length, target quantity, batch qty and other processing parameters.

    It comes with in-built production counter, which indicates the number of cuts taken.

    The standard machines can cut heat shrink tubes from 3mm dia to 20 mm dia. Round tubes of upto 10 mm diameter can be cut on this machine.

    Depending upon the length, the machine can process around 3000-12000 pieces per hour. (You may require separate de-reeler to provide free sleeve to machine.)

    The machine works on single-phase electric supply and 5 bar pneumatic supply.

    One should have a compressor of 2 hp capacity to utilize this machine fully.

    Special machines for other specific customer needs can also be developed by m/s ‘machine makers r.s.

    ∗ "MICROPROCESSOR controlled machines with smart display.
    ∗ Fully automatic machine. Setting is completely digitized and mostly automatic.

    Performance Range

    Material Types & Cross section  Heat shrink tubes: from 3mm dia to 20 mm dia.
    Round tubes : upto 10 mm diameter can be cut on this machine.
    Flexible Copper wire: upto 6 sq mm.
    Power chords upto 3 core x 2.5 sq.mm
    Length Selection Standard range: 5 mm to 9 meters, in steps of 1mm; You may require separate de-reeler to provide free sleeve to machine.
    Accuracy +/- 0.2% (min. +/-1 mm), Mostly you will get within +/- 0.5 mm
    Multiple Wire Processing Possible with special guide and blades in selective cases
    Changeover setting time 30 sec to 5 minutes typically.

    Technical Data

    Mechanical system Rugged machine with precision mechanical system
    Electronic system Separate electronic control with PLC and drives
    Tube feed system 1 stepping motor with 2 feed rollers, variable speed
    Cutting system *** Pneumatic Cylinder and Solenoid Valve With 1. Simple centralizing cutter. 2. Optional single sided cutter also available. Customers are requested to submit the sample of sleeves / tubes. This helps in selection of the cutter.
    Length Measurement system  Directly by stepping motor control
    Power  220V / 50 Hz, other options upon request
    Compressed air 5 to 6 bar, 180 lpm (1.5 hp compressor)
    Dimensions 350mm X 350mm X 435mm(h), approx

    Production Speed* :

    Length 10 mm 100 mm 500 mm 1000 mm
    Output 12000 / Hr 5500 / Hr 3500 / Hr 2500 / Hr

    Speed for 0.5 sq mm multi-strand wires/ 8 mm heat shrink tube.

    Voltage servo-stabilizer (2KVA) or CVT (1KVA) is must. Proper earthing is essential. *** Customers are requested to submit the sample of sleeves / tubes. This helps in selection of the cutter.